Process Engineer

Process Engineer /Process Design Engineer

Process design and engineering experience of 8 to 12 years in Oil & Gas projects upstream projects pipeline projects covering design conceptual engineering FEED Detailed engineering.

Required Experience:

The candidate should have experience in preparing the following deliverables for Basic Engineering FEED or EPC projects with a reputed international EPC consultant.

• Design Basis
• Licensor Technology Evaluation
• PFD and P&ID Preparation and or review for Urea Plant
• HMB
• Process data sheets Equipment list Line list Load list Tie-In list Fluid list
• PSV Relief load estimation PSV sizig
• Flare sizing KOD sizing
• Pump sizing
• Compressor Calculations Anti surge design settle out calculations etc
• Steam generation and sizing calculations
• Design of Separators columns Heat Exchangers tanks
• Hydraulic calculations PSV sizing Control valve sizing calculations
• Interfacing with Piping Mechanical Instrument engineers Commissioning Engineers as required during the EPC stages
• 3D Model Review
• vendor offer reviews
• Experience across conceptual design FEED and detailed engineering phases.
• Operation experience is not preferred.

Software/Technical Skills & Tools

- Experience with process simulation and engineering software such as HYSYS PROMAX Flare network analysis tools and HTRI.

- Strong understanding of process design sizing and optimization techniques.

- Ability to critically review calculations and propose practical engineering solutions.

- Strong technical documentation and report-writing skills.

- Fluent in spoken and written English.

Education:

• B tech Chemical Engineering / MTech Chemical Engineering
• 75% Marks in engineering are mandatory

Job Profile

Key Responsibilities

- Perform process design review and verification across conceptual FEED and detailed engineering stages.

- Prepare and review process design basis philosophies and engineering calculations.

- Review and verify Process Flow Diagrams (PFDs) Piping & Instrumentation Diagrams (P&IDs) and Heat & Material Balances (HMB).

- Review process datasheets equipment lists line lists tie-in lists fluid and load lists.

- Perform and review PSV relief load estimation and PSV sizing calculations.

- Review flare system calculations knockout drum sizing and associated hydraulics.

- Review pump compressor and rotating equipment process calculations including anti-surge and settle-out analyses.

- Review design of separators columns heat exchangers tanks and other process equipment.

- Perform hydraulic calculations and control valve sizing reviews.

- Interface with piping mechanical electrical and instrumentation disciplines during EPC execution.

- Participate in 3D model reviews and vendor technical document reviews.

- Prepare and review technical reports calculation notes and design review comments.

- Ensure compliance with applicable international codes standards and project procedures.

- Site Visit : The candidate may be required to occasionally visit project sites to conduct audits or verification activities.

Location: Abu Dhabi UAE